User Manual

Chapter 5 Main panel window
Amp Editor Owner’s Manual
85
IP Control Port No.
Click the [Device] menu command [IP Control Port No....] to access the “IP Control Port No.” dialog box. For
each device, you can specify the Ethernet port number that will be used for remote control from an external
remote controller via the remote control protocol. Click [OK] to apply the modified settings and close the dialog
box.
• This can be set only when offline.
• When you click the [OK] button, communication with the specified device will be broken and the device
icon will temporarily be dimmed in the Tree View window.
 Device
Selects the device whose port will be changed. The current port setting of the selected device is shown below.
 IP Control Port No.
Specifies the Ethernet port number (49152–49407) that will be used for remote control from an external
remote controller via the remote control protocol. All devices in the network can communicate on the same
port number. Change the port number if there are other devices (other than the TXn/ACD1) that use the same
port number.
• The XMV will display the static address “49280”.
NOTE
NOTE