User Manual

Chapter 3 Setup
Amp Editor Owner’s Manual
22
 Setting the device IP address (example for an XMV)
On the XMV, the IP address is automatically specified based on the unique UNIT ID of each device. The follow-
ing procedure is based on the assumption that these IP address settings are used for communication between the
devices and Amp Editor.
1. Before turning on the power to the devices, use an Ethernet cable to connect your com-
puter’s Ethernet connector to the network switch, and then start up the computer.
2. Click [Start]  [All Programs]  [Yamaha Amp Editor]  [Amp Editor] to start Amp Edi-
tor.
3. From the Amp Editor menu bar, choose [System]  [Network Setup].
The “Network Setup” dialog box will appear.
4. In [Network Interface], select the network adapter you’re using.
As the network adapter, select the same card as you used in “Computer’s IP address setting.”
5. If you are using the XMV4140-D, XMV4280-D, XMV8140-D, or XMV8280-D, and if the
[Enable] checkbox in the Auto IP Address Assignment section is checked, uncheck it to
disable the Auto IP Address Assignment function (page 92).
6. Make sure that the device setting DIP switch (IP SETTING) on the XMV’s rear panel is set
to UNIT ID.
7. Use an Ethernet cable to connect the [NETWORK] connector of the XMV to a network
switch, and then power-on all devices.
8. Verify that all connected devices are shown in the Tree View window.