User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Chapter 2 An overview of Amp Editor
Amp Editor Owner’s Manual
13
Saving a project
1. In the main panel window, click [File] menu [Save].
The currently-open project will be overwritten.
Save as a specified name
The main panel window [File] menu [Save As...] command lets you save the currently-open project with
the name you specify. If you’re saving for the first time, a project will be created. If the project has already
been assigned a name and saved, it will be saved as a different project.
1. In the main panel window, click [File] menu [Save As...].
The “Save Project As” dialog box will appear.
When saving the library file with a project, select the [Copy library data from the user library folder.]
check box. If you click the [OK] button, the [Select Library] dialog box will appear. This dialog box
shows the library files are saved to the User Library folder. Select the library file to be copied to the proj-
ect folder, and then click the [OK] button.
• If a library file of the same name already exists in the destination for the project, the dialog box
will ask whether you want to overwrite, or save the library file as a specified name with num-
bers. When you save it as a specified name with numbers, a list of the library files that were
most recently saved (starting with the same letters as that specified name) will be displayed.
2. Enter the name under which you want to save the project, and click the [OK] button.
The folder selection dialog box will appear.
3. Select or create the folder in which you want to save the project, and click the [OK] but-
ton.
The project will be created.
NOTE