User Manual

Chapter 8 Device Properties window

Amp Editor Owner’s Manual

133

 [Limiter] tab (TXn only)

Here you can specify the limiter values for each amplifier.

These settings can be changed when online or offline.

q Voltage Limiter

These settings specify how the limiter will be controlled by the output voltage.

 Check box

Turns the limiter on/off.

 Threshold

Specifies the upper threshold value for the output voltage.

Click the [  APPLY] button to specify the value calculated in the “Calculate the Output Voltage.”

 Attack

Specifies the time over which 20 dB of attenuation will be applied after the threshold value is exceeded.

 Release

Specifies the time over which the voltage that had been attenuated will be returned to the original level

after the voltage falls back to below the threshold value.