User Manual

Chapter 5 Main panel window
Amp Editor Owner’s Manual
42
 [Meter Unit] tab
For each type of amplifier, you can specify the index and parameter units of the meters shown in the Detail View
window and the Device Properties window.
 [Analog Input]
Here you can select the units of the Analog Input level meter as “dBFS,” “dBu” or “V.”
 [Speaker Output]
Here you can select the units of the Speaker Output level meter as either “dBu” or “V.”
 [Peak Hold] check box
If this is checked, peak hold will be enabled for the level meter. The peak hold setting is valid only within
Amp Editor. It is not linked with the settings of the amplifier itself.
 [Enable Level Meters] check box
The level meter will be enabled if this is checked.