User Manual

Chapter 5 Main panel window
Amp Editor Owner’s Manual
92
 Network Interface

[Network Interface] box
Selects the network interface card to which the device you want to connect is connected.
 IP Address/Subnet Mask
This indicates the IP address and subnet mask assigned to the selected network interface card.
 Auto IP Address Assignment
This section displays the range of IP addresses that can be assigned.
 Enable check box
Check the [Enable] check box so that the Auto IP Address Assignment function will assign an IP address to
each device.
• If the Auto IP Address Assignment function remains enabled, the IP address of devices other than
the amplifier on the same network might be affected. For example, if Dante-enabled devices, such
as the XMV4140-D, XMV4280-D, XMV8140-D, or XMV8280-D, are connected to the same network,
and Amp Editor is started while the Auto IP Address Assignment is enabled, certain problems may
occur, such as temporary audio interruption on the Dante network. Therefore, once you assign an
IP address to your amplifier, it is recommended to disable the Auto IP Address Assignment function.
 Change Range button
Click this button to display the “IP Address Range” dialog box to specify the range of the IP address to be
assigned.
• This can be changed only when offline.
NOTE
NOTE