User Manual

Chapter 7 Detail View window
Amp Editor Owner’s Manual
125
t Redundant Mode (TXn only)
Indicates the amplifier’s input redundant mode (Redundant Backup/Override/Off). To change the mode, use
the Device Properties window [General] tab.
y Amp Mode (TXn/Tn/PC-N/XP/XM only)
Indicates the amplifier’s output mode (Stereo/Parallel/Bridge). To change the mode, use the Device Properties
window [General] tab (page 131).
u Amp Gain/Sensitivity (TXn only)
Indicates each channel’s gain and input sensitivity values. To change the settings, use the Device Properties
window [General] tab.
i [Device Properties] button
When you click this, the Device Properties window will appear (page 127).
o Redundancy (XMV V3.1 or later)
Indicates the status of the analog or digital input and redundancy.
To make redundancy settings, use the Device Properties window [Input (V3.1 –)] tab (page 128).
Redundant Indicator
Indicator
Input
Souce
Input
Redundancy
Redundancy
Enabled
Status
Analog — — —
Dante
or
YDIF
——
Other than Off
Audio signal is input from the digital con-
nector.
Redundant
Override
Audio signal is input from the analog
connector by the Redundancy Override
function.
Redundant
Backup
Audio signal is input from the analog
connector by the Redundancy Backup
function.


