User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Chapter 10 Component editor (TXn only)
Amp Editor Owner’s Manual
167
Specifying a routing
To change a routing, click the point where an input channel and output channel intersect. When you place the
cursor on a cell, the input/output channels will be highlighted, and a blue line will be displayed. When you
click, a routing will be established at that position. If another output channel was already assigned to the input
channel on which you clicked, the previous assignment will not be cancelled. If another input channel was
already assigned to the output channel on which you clicked, the previous assignment will be cancelled.
Cancelling a routing
Click the “” that indicates a routing; that routing will be cancelled, and the “” will disappear.
Polarity (phase reversal)
Here you can reverse the phase of the signal. The phase will be reversed if the button is on.
Click
The other input channel is cancelled
Click