User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Chapter 10 Component editor (TXn only)
Amp Editor Owner’s Manual
172
Oscillator
This is a mono-channel oscillator. It generates a sine wave, pink noise, or burst noise.
Pink noise
This is a reference signal used for acoustical measurements. Across the frequency band of 20 Hz–20 kHz,
doubling the frequency will halve the energy. The loudness will be the same for each frequency band.
Burst noise
Pink noise will be output intermittently.
Section Parameter Range Function
q
Wave Form
Sine
100Hz, 1kHz,
10kHz, Vari
Selects the frequency/waveform that will be gen-
erated. You can select only one of the six [Sine] or
[Noise] buttons.
w Noise Pink, Burst
e Frequency 20Hz–20kHz
If you selected the Sine wave [Vari] as the Wave
Form, this specifies the frequency of the sine
wave that will be generated.
r
Output
Level -
–±0dB Specifies the output signal level.
t ON On/Off Switches the oscillator on/off.
q
e
w
t
r