User Manual
Table Of Contents
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Starting Dante Controller
- Using Dante Controller
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2014 Audinate Pty Ltd. All rights reserved.
-6-
Multicast Transmit Flow Configuration 65
Presets 67
About Device Roles 67
Saving Presets 68
Parameter Rules 68
Rx Subscriptions 68
Tx Flows (multicast flows) 69
Tx Channel Labels 69
Applying Presets 69
Preset Elements 70
Preset Roles 70
Automatic Assignments 71
Manual Assignments 72
Target Devices 72
Issues 73
Applying the Preset 73
Global Configuration 73
Troubleshooting 75
Fanout 75
About Transmit Flows 75
Messages on Startup 75
Computer Configuration Checklist 76
Third-party firewall configuration 76
Troubleshooting Dante IP Address Configuration 76
Correct IP configuration 77
Possible IP network configuration mistakes 77
Incorrect PC/Mac IP configuration 77
Incorrect general IP configuration 77
Incorrect redundant network configuration 77
What are the symptoms of using the wrong network interface on my computer? 78
How do I check which network interfaces Dante Controller is using? 78
How do I check IP addresses for all devices on my network? 78
Troubleshooting Switch Configuration and Cabling 79
Symptoms of switch or cabling issues 79
Switch and Cabling Checklist 79
Index 80