User Manual

MTX3/MTX5-D/MRX7-D/XMV Series/EXi8/EXo8 Remote Control Protocol Specications V3.1.0 rev10
37
3. Command Specications
3-13) DST enable/disable setting
Command Option 1 Option 2 Description
event MTX:DSTSetEnable "enable" Set DST enable
"disable" Set DST disable
Response
Response string Description
OK event MTX:DSTSetEnable "enable" DST was enabled
OK event MTX:DSTSetEnable "disable" DST was disabled
Example: Command: event MTX:DSTSetEnable "enable"
Notication: OK event MTX:DSTSetEnable "enable"
Meaning: Set DST enable
DST was enabled
3-14) DST enable/disable query
Command Option 1 Option 2 Description
event MTX:DSTGetEnable "" DST enable/disable query
Response
Response string Description
OK event MTX:DSTGetEnable "enable" DST is enable
OK event MTX:DSTGetEnable "disable" DST is disable
Example: Command: event MTX:DSTGetEnable ""
Notication: OK event MTX:DSTGetEnable "enable"
Meaning: Get DST setting
DST is enable
3-15) DST status query
Command Option 1 Option 2 Description
event MTX:DSTGetStatus "" DST status query
Response
Response string Description
OK event MTX:DSTGetStatus "on" Working with DST
OK event MTX:DSTGetStatus "off" Not working with DST
Example: Command: event MTX:DSTGetStatus ""
Notication: OK event MTX:DSTGetStatus "on"
Meaning: Get DST working status
Working with DST
3-16) DST offset time setting
Command Option 1 Option 2 Description
event MTX:DSTSetOffset "offset=hh:mm" Set DST offset
Details: hh = Hour (0 to 2)
mm = Minute (0 to 59)
(Up to 2 hours can be set)
Response
Response string Description
OK event MTX:DSTSetOffset "offset=hh:mm" DST offset was set
Details: hh = Hour (0 to 2)
mm = Minute (0 to 59)
Example: Command: event MTX:DSTSetOffset "offset=1:00"
Notication: OK event MTX:DSTSetOffset "offset=1:00"
Meaning: Set DST offset to 1 hour
DST offset was set to 1 hour