User Manual
Table Of Contents
- Copyright
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Discovery and auto-configuration
- Device Channels
- Differentiating between input and output channels
- Device Names and Channel Labels
- Routing Audio
- Clock Synchronization
- Latency
- Device Lock
- Dante Control and Monitoring
- Starting Dante Controller
- Using Dante Controller
- Network View
- Status Bar
- Network View Tabs
- Channel Groups
- Clock Status Monitoring
- Clock Status Monitor
- Automatic Notification of Device Errors
- Device View
- Device View Tabs
- Multicast Transmit Flow Configuration
- Using Dante Controller with Dante Domain Manager
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2018 Audinate Pty Ltd. All rights reserved.
-31-
Note: When connecting a network interface on your computer to a secondary Dante network with no
DHCPserver, the network interface should be configured with a static IPaddress in the 172.31.*.*
range, with a subnet mask of 255.255.0.0.
The icons displayed indicate the selected interface type and status:
Operational 1Gbps Ethernet interface
Operational 100Mbps Ethernet interface
Disabled / disconnected Ethernet interface, or no interface selected
Operational Wi-Fi interface
Wi-Fi interface selected with no Wi-Fi network connection
To display this dialog at any other time, click the button in the main toolbar.