User Manual
Table Of Contents
- Copyright
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Discovery and auto-configuration
- Device Channels
- Differentiating between input and output channels
- Device Names and Channel Labels
- Routing Audio
- Clock Synchronization
- Latency
- Device Lock
- Dante Control and Monitoring
- Starting Dante Controller
- Using Dante Controller
- Network View
- Status Bar
- Network View Tabs
- Channel Groups
- Clock Status Monitoring
- Clock Status Monitor
- Automatic Notification of Device Errors
- Device View
- Device View Tabs
- Multicast Transmit Flow Configuration
- Using Dante Controller with Dante Domain Manager
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2018 Audinate Pty Ltd. All rights reserved.
-83-
Rack Sample Rate
The sample rate at which the rack is currently set to.
Rack Mute Status
The mute status of the rack.
Avid Dante card Control
This section allows high-level configuration of the DNT-192 card.
Card Configuration
In ‘Dante’ mode the card configuration is automatically set by the rack. In ‘Generic’ mode the configuration
is manually selectable.
The Card Configuration option supports 3 values:
n Input card: The card functions as a 16-channel input device
n Output card: The card functions as a 16-channel output device
n Input/Output card: The card functions as an 8-in + 8-out device
SRC
Sample Rate Conversion.
When enabled, the card will convert incoming (Rx) audio to the Rack Sample Rate (if required), and
outgoing (Tx) audio to the sample rate of the receiving device on the Dante network (if required).
Note that SRC adds latency of roughly 1.3ms to the Dante subscription in each direction.
Card Identity
n Dante: The card will identify itself as a Dante device to the host device rack, enabling Dante func-
tionality on the host device. Required for Dante-enabled host equipment.
n Generic: The card will identify itself as a generic digital audio interface (required for non-Dante host
equipment).
Multicast Transmit Flow Configuration
Click the Multicast Configuration button in the Device View to open the Create Multicast Flow dialog.