User Manual

26. DCP
26.1. Overview
The DME7/MTX5-D/MTX3 parameters can be assigned to the operators of a digital control panel (DCP) such as
the DCP1V4S, and controlled from the DCP. In addition, the brightness of the LEDs on the DCP unit can be set, as
well as a panel lock. Settings cannot be made while in an online state (settings can only checked).
26.2. How to select the DCP to be connected
First, select DME7/MTX5-D/MTX3 in the Project sheet, and select the DCP for the Properties area.
After that, use the screen below to select the DCP that has been connected to the DCP port.
26. DCP
324 | ProVisionaire Design User Guide