User Manual

17.7.2. "Redundancy" component editor
This appears when you double-click the "Redundancy" component.
This is the component editor to use if you want to make settings while hearing the sound when the redundancy
mode is "Backup."
•
"REDUNDANT MODE"
This indicates the status of redundancy mode.
•
"PILOT TONE DETECTION"
Here you can make settings for pilot tone detection.
◦ [Freq.[Hz]] knob
Specifies the center frequency of the pilot tone.
◦ [DETECTION THRESHOLD] knob
Specifies the input level threshold value for the pilot tone. Input that exceeds the threshold value is
considered to be the pilot tone.
◦ [DETECTION TIME] knob
Specifies the detection time for the pilot tone. If the pilot tone can not be detected for the specified
time interval, it is determined that the input has ceased.
•
"NOTCH FILTER"
Here you can make settings for the notch filter that prevents the pilot tone from being output from the
amp.
◦ [ON] button
If this is on, a notch filter is enabled to eliminate the frequency component of the pilot tone so that
the pilot tone is not output from the amp.
◦ [Q] knob
Specifies the width of the frequency band for the notch filter.
17. Power Amplifiers : XMV-series
286 | ProVisionaire Design User Guide