User Manual

22. Microphones : PGM1
22.1. Overview
This is a paging microphone for use with the MTX series.
A paging system can be created using the PGM1.

Because the PGM1 settings are stored by the MTX, it is normally not necessary for
ProVisionaire Design to discover the PGM1.
When using ProVisionaire Design to change the IP address of the PGM1 or to perform a
firmware update, please install Bonjour Print Service to allow ProVionaire Design to discover
the PGM1.
22.2. "Project" sheet
When placing devices, the Settings screen shown below will be displayed.
•
Number of Devices
Selects the number of PGM1 units placed on the device sheet.
•
Unit ID Starting From
You can select the starting number for the device Unit IDs.
•
Device Name
The device name can be displayed and edited.
After adding the PGM1 to the project, select the PGM1 to be used by each device.
The connection between the equipment and PGM1 is made from the "Properties" area > PGM1 on the Project
sheet.
The PGM1 settings should be specified using the editor of the paging component on each device sheet.
For the MTX series, this is launched from "Paging" in the Zone component displayed in the device sheet.
22. Microphones : PGM1
302 | ProVisionaire Design User Guide