User Manual

7.5. Placing devices
Here we explain how to place devices on the "Project" sheet.

• If any object in the "Devices" area or "Network" area is selected, pressing an
alphabetical key will select the component of the matching initial letter.
•
Drag and drop a device from the "Devices" area into the "Project" sheet.
You can select the number of devices and the UNIT ID. The UNIT ID can be changed in the "Properties"
area.
• Connect the computer to the network of devices, and then drag and drop a device from the "Network"
area into the "Project" sheet.
If a device that you understand to be connected is not shown in the "Network" area, check that the device
actually is connected to the network, and that it is powered-on.
Speakers are not shown in the "Network" area.

• Double-click [Device Group] to select Stamp mode, and then click the "Project" sheet to
place a [Device Group] each time you click the sheet.
To exit Stamp mode, press < Esc >.
7. "Project" sheet
42 | ProVisionaire Design User Guide