User Manual

20
Owner’s Manual
Other functions
Initializing the RSio64-D
To return (initialize) the internal memory to its factory-set
state, for example if you move the unit to a different
location, proceed as follows.
1. Turn the unit off.
2. On the front panel, set device setting DIP
switch 7 down and switch 8 up (INITIALIZE).
3. Turn the unit on.
Initialization begins. When initialization is completed,
the SLOT 1–4 [LOCK] and SLOT 1–4 [SRC] indicators
flash green and red alternately.
4. Verify that initialization is completed, and turn
the unit off.
5. Set device setting DIP switches 7 and 8 both up
(NORMAL).
6. Turn the unit on.
The following parameters are initialized.
(*1) The third and fourth characters of the Dante device label
depend on device setting DIP switch 1 and the SETUP [UNIT
ID] rotary switch. The lower six digits depend on the lower six
digits of the unit’s MAC address.
* When shipped from the factory, all of the device setting DIP
switches are set to the upward position.
Updating the RSio64-D’s
hardware settings
If the SLOT 1–4 [LOCK] indicators and the SLOT 1–4
[SRC] indicators are alternately flashing red and the unit
does not start up, it may be that the unit’s hardware settings
were not updated when updating the firmware. In this case,
proceed as follows to update the RSio64-D’s hardware
settings.
1. While holding down the SLOT 3 [SRC] key, turn
the power on again.
Updating of the unit’s hardware settings begins. During
the update, the SLOT 1 [LOCK] indicator and the
SLOT 1 [SRC] indicator light simultaneously. To
indicate the status during the update process, both the
[LOCK] indicator and the [SRC] indicator successively
light in the order of SLOT 2  SLOT 3  SLOT 4.
When the update is completed, the eight indicators
flash once and then return to the normal illumination
status.
If you are using the card’s
SRC
If your card features an SRC (MY8-AE96S), you can use the
card’s SRC instead of the main unit’s SRC.
To use the card’s SRC, set device setting DIP switch 6 on the
front panel to the down position.
When this function is enabled, the [SRC] key on the front
panel of the main unit will be used to turn the card’s SRC
on or off.
• Changes made to device setting DIP switch 6 will
become effective in three seconds.
• For a slot that has a card without an SRC inserted, the
[SRC] key will turn the unit’s SRC on or off regardless of
the switch position.
Parameter Initialized setting
SLOT 1–4 SRC OFF
WORD CLOCK SELECT DANTE/48 kHz
USER PATTERN
Same routing settings as preset pat-
tern 1
STATIC IP (Manual) 0.0.0.0
Panel Lock Lock defeated
Dante patches All off
Dante device label Y001-Yamaha-RSio64-D-123456
(*1)
7 8
ON
12345678
7 8