User Manual

Yamaha Commercial Audio
Dante-MY16-AUD HA Remote Control Guide
13 www.yamahaproaudio.com
Using an External Word Clock Generator
In the Word Clock menu of the mixer, select “Word Clock In” as the clock source.
Open Dante Controller software and select the Clock Status tab. Set “Slave to
External Clock” for just one of the Dante-MY16-AUD cards that are installed in the
mixer. For the same card, check the “Preferred Master” option, and this card will
transmit the word clock to the rest of the network.
EXTERNAL HA Settings
Next, on your digital mixer, open the EXTERNAL HA screen (or the REMOTE
screen). At this screen, you can see the connected external HA equipment
(the R series in this description) virtually mounted onto the rack as AD8HR.
M7CL-48: RACK -> EXTERNAL HA screen LS9-32: RACK -> EXTERNAL HA screen
COMM PORT
Select a port that transmits/receives an HA control signal. For the LS9 or the
M7CL-48ES, choose SLOT 1. The other equipment (such as the M7CL-48/32 and
the PM5D) has no setting (only the HA REMOTE terminal is available).
EXTERNAL HA PORT
Select an audio input port (for eight channels of a slot) for each virtual rack. Make
sure to match the rack number with the virtual ID on the HA device.
When configuring the above settings, you can open a rack from the
EXTERNAL HA screen to control the HA. Moreover, when patching a
corresponding slot input to an input channel, you can adjust the external HA
from the input channel controls.