User Manual

Connecting Yamaha Dante devices with AES67
3
 Do not change the TX multicast address prefix (default 239.69).
 Do not change the bit depth (default 24 bit) from Dante Controller or the console after
enabling the AES67 mode. Rebooting the device or Dante module with the change
could reset the multicast addresses if using a different multicast address prefix other
than default 239.69, which would cause audio interruption.
 Do not change the multicast addresses and labels of non-Dante AES67 transmission
flows patched to Dante AES67 devices. The change could cause audio interruption.
 If the device labels are changed, reboot the Dante module. The AES67 transmission
flow labels will not be updated until after the reboot.
Configuring the Dante devices
1. Open the AES67 Config tab of the device in Dante Controller v3.6.2.4 or later.
The tab will not appear if the device firmware does not support AES67 yet.