User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
WORD CLOCK screen
The WORD CLOCK screen is for configuring the word clock of the DM3 series.
a b
c
a
Leader clock frequency
Displays the state of the current leader clock.
(
96 kHz :
Synched at 96 kHz
(
48 kHz :
Synched at 48 kHz
(
Unlock :
Not synched
b
Leader clock selection button
Selects the frequency to use for the leader clock.
c
Dante clock display (DM3 only)
Displayed when it becomes the clock leader or the clock follower in the Dante audio network.
NOTE
(
The leader clock cannot be changed when a Device Lock is applied by the Dante Controller.
(
The leader clock cannot be changed when enrolled in the domain of Dante Domain Manager (DDM).
(
The leader clock cannot be changed from 48 kHz to 96 kHz when the AES67 Mode mode is Enabled.
101
Screen functions and names > SETUP screen