User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
d
SYSTEM and SYNC indicators
Displays the status of DM3 and Dante
When there is an error, warning or information, its corresponding icon is displayed.
Touch to display the message at the bottom of the screen.
e
Preferred Leader button
Turns the Preferred Leader ON/OFF.
Turning On increases the priority on the leader in the Dante audio network. Turning Off decreases the priority on the
leader in the Dante audio network.
NOTE
(
If there is only 1 device in the Dante audio network set to On, that device becomes the leader.
(
If more than 1 device in the Dante audio network is set to On, one of them will be the leader.
(
If all devices are set to Off, then any 1 of the Dante devices, including I/O devices, will be the leader.
f
Bit selection button
Select either 24-bit or 32-bit.
g
Latency selection button
For selecting the Latency of Dante.
h
Dante Patch button
Touch to display the DANTE PATCH screen.
110
Screen functions and names > SETUP screen