User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
NOTE
(
The default setting for Preferred Leader is On. When Preferred Leader only of a device that is always running is turned ON with the
Dante Controller, (all others OFF), you can explicitly specify the leader.
(
Settings like Latency, Bit, and Preferred Leader cannot be changed when Device Lock is set with the Dante Controller or if enrolled
in the domain by Dante Domain Manager (DDM).
(
When enrolled in the Dante Domain Manager domain, the DANTE PATCH screen cannot be opened. Similarly, the DANTE PATCH
screen cannot be opened if the IP address of For Device Control of the NETWORK screen and the subnet of the IP address displayed
by Preferred Leader do not match.
Related links
(
“Dante”(p.342)
(
“DANTE PATCH screen”(p.112)
111
Screen functions and names > SETUP screen