User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
DANTE PATCH screen
The DANTE PATCH screen displays the current state of Dante patches and allows settings to be made.
You can also load Dante patch libraries, enable them and automatically configure specified I/O devices.
When enrolled in the Dante Domain Manager domain, the DANTE PATCH screen cannot be opened. Similarly,
the DANTE PATCH screen cannot be opened if the IP address of For Device Control of the NETWORK screen
and the subnet of the IP address displayed by Dante Controller do not match.
a
cb
a
Dante patch display
Displays the current state of Dante patches.
Settings complete
Offline
Error
b
Library button
Loads Dante patch libraries.
Touch to display the DANTE PATCH LIBRARY screen.
112
Screen functions and names > SETUP screen