User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
BRIGHTNESS screen
The BRIGHTNESS screen allows you to set the brightness of the LEDS on the touch screen and top panel, as
well as that of the channel name area. Brightness settings can be saved in 2 types of banks, A/B, and you can
switch between them as needed.
a b
c d e
a
Bank switching buttons
Switches between the brightness settings saved for Bank A/B.
(
BANK A :
Displayed at the brightness of BANK A.
(
BANK B :
Displayed at the brightness of BANK B.
b
Power Saving Mode selection button
Sets the time to switch to the power saving mode.
You can choose from Never, 30 seconds, or 2, 5, 10, or 15 minutes.
127
Screen functions and names > SETUP screen