User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
NETWORK (For Device Control) screen (DM3 only)
The NETWORK (For Device Control) screen is for setting the network address required when controlling
devices in a Dante audio network.
a b c d
a
IP address acquisition method buttons
For selecting the method of acquiring an IP address.
(
DHCP :
Automatically acquires an IP address DHCP (Dynamic Host Configuration Protocol).
(
Static IP :
For setting the IP address yourself.
b
IP Address
Sets the address that identifies an individual device within the Dante audio network.
c
Subnet Mask
Defines how many bits of the IP address used in the Dante audio network are used in the network address, which
identifies the network.
d
Gateway
Within a Dante audio network, this sets the address that identifies the device (gateway) that converts data of
different media or protocols to each other.
131
Screen functions and names > SETUP screen