User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
NOTE
(
When DHCP is selected as the IP address acquisition method, settings b to d are not necessary. If Static IP is selected, a screen
opens for setting b to d. Enter the values for each item.
(
Set different subnets for For Mixer Control and For Device Control.
(
If the subnets of the IP address set with For Device Control and the IP address of the PRIMARY port of the DM3 recognized with
Dante Controller are not the same, DM3 will not be able to find devices in the Dante audio network. As such, the current Dante
patch status display, Dante Auto Setup, Dante patch library auto setup, and remote HA functions cannot be used. To set Dante
patches in this state, use Dante Controller. At such time, if you touch the Dante Patch button on the DANTE (Setup) screen, a
message is displayed at the bottom of the screen indicating the subnet settings are different.
132
Screen functions and names > SETUP screen