User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
MIX 1-6
Following is a description of the SELECTED CHANNEL section of the MIX 1-6 channels.
hf g
e
dcba
i
a
Displays the SEND FROM screen. (p.219)
b
Displays the DELAY screen. (p.187)
c
Displays the LIBRARY screen. (p.221)
d
Sets the RTA Offset.
Adjusts the sensitivity of RTA. Touch to highlight and then adjust with the [TOUCH AND TURN] knob.
e
Sets the GEQ of channels.
Touch to highlight and then turn the [TOUCH AND TURN] knob to adjust the parameter.
Touching the GEQ ON FADER mark to turn it on, enables the faders on the top panel.
Touch the jump button to open the GEQ screen. (p.211)
f
Displays the CH VIEW screen. (p.197)
g
Displays the OUTPUT screen. (p.214)
152
HOME screen > SELECTED CHANNEL section