User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
a
INPUT PATCH buttons
Allows you to select the input channel's input source (input port).
(
IN :
Input from a device connected to the [INPUT] jack.
(
DANTE :
Input from the Dante port. Use this when selecting an input from a Tio1608-D or stage box connected to DM3 and
Dante.
(
USB :
Input from a computer connected to the [USB TO HOST] connector.
(
FX :
Input from FX BUS.
(
PB :
Input from Playback. For selecting input from a storage device plugged into the USB connector on the top panel.
Touch the jump button to open the INPUT CH PATCH screen.
NOTE
(
When USB is selected, the gain slider becomes digital gain and the +48V button is hidden.
(
DM3 STANDARD cannot be used with Dante.
(
When DANTE is selected and input is from a device that cannot operate the head amp, the gain slider becomes digital gain
and the +48V button is hidden.
Even if the input source is set to DANTE, OFFLINE is displayed if the DANTE device is on an offline channel, or if DANTE
is working on a secondary port.
171
Channel-specific screens > INPUT screen