User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
DYN2 (COMP) screen
The DYN2 screen allows you to configure the compressor for each channel.
This screen also allows you to switch between the easy to operate 1-knob mode with the [TOUCH AND TURN]
knob and the manual mode, where individual parameters can be manipulated.
b c d ea
h jk l nf g omi
a
DYN2 button
Turns the DYN2 function ON/OFF.
b
1-knob button
Switches between 1-knob mode and manual mode.
c
1-knob level slider (only displayed in 1-knob mode)
Adjusts the amount of 1-knob COMP applied.
Not displayed during manual mode.
d
Attack slider
This sets the time from when the input signal exceeds the value set by the Threshold slider until the full compressor
effects is reached.
184
Channel-specific screens > DYN2 (COMP) screen