User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
e
Key In selection button
Select the Key In signal from the following.
(
Self Pre EQ
(
Self Post EQ
f
Key In level meter
Displays the Key In input level.
g
DYN2 input level meter
Displays input level to DYN2.
h
Threshold slider
Sets the level at which the compressor is applied.
i
Compressor graph
Displays a visual representation of the current settings.
j
Ratio slider
Determines the amount of compression that is applied.
k
Release slider
This sets the time from when the input signal drops below the value set by the Threshold slider until the compressor
effect disappears. The setting value indicates the time required for the level to change by 6 dB.
l
Knee buttons
Determines how gradual or sharp the curve is at the threshold. With Soft the compressor is applied smoothly, with
Hard, rapidly.
m
Out Gain slider
Adjusts the output level of the compressor.
n
GR (gain reduction) meter
Displays the amount by which the signal's gain is reduced.
o
OUT (output) meter
Displays the compressor output level.
n
DYN2 screen menu
Swipe left on the menu swipe indicator on the right of the DYN2 screen to open the following menu.
185
Channel-specific screens > DYN2 (COMP) screen