User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
CHANNEL STRIP section
The CHANNEL STRIP section corresponds to the channel module of a conventional analog mixer and it
operates the main parameters of the selected channel. The channels assigned on the CUSTOM FADER BANK
screen can be customized.
a
b
c
d
a
[SEL] key
This key selects the channel to be operated. Pressing this key makes it light and that channel is selected on the
display as being subject to operation. With stereo channels, each press of the [SEL] key toggles between the L/R
channels.
b
[CUE] key
The [CUE] key selects the channel to monitor. It lights when the CUE is ON.
c
[ON] key
Toggles the channel ON/OFF. This key lights for channels that are ON. In the SENDS ON FADER mode, the signal sent
from that channel to the currently selected MIX BUS, FX BUS, or MATRIX BUS is toggled ON/OFF.
d
Fader
Faders adjust the signal level of the channel. In the SENDS ON FADER mode, it adjusts the send level from that
channel to the currently selected MIX BUS, FX BUS, or MATRIX BUS .
19
Controls and functions > Top panel