User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
f
FX send level slider
Displayed for CH 1-16, ST IN, FX RTN 1-2.
For adjusting the send level to the FX BUS.
g
Pre button
Displayed for CH 1-16, ST IN, FX RTN 1-2.
Allows you to select whether the pre-fader or post-fader signal is sent to the FX RTN channel.
(
ON:
Just before the fader
(
OFF:
After the fader
h
Parameter sliders
Allow you to adjust the parameters available for the current effect.
i
Parameter slider selection buttons
Touch to display other parameter sliders available for the current effect.
j
FX output level meter
Displays the output level of the FX module.
k
CUE button
Turns the FX module CUE ON/OFF.
n
FX screen menu
Swipe left on the menu swipe indicator on the right of the FX screen to open the following menu.
a
b
c
d
190
Channel-specific screens > FX screen