User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
f
SEND TO box
Touch while selected to open the SEND TO screen.
Uses a white line to indicate the amount of signal from the selected channel that is sent to the MIX/MATRIX channels.
Send levels, the selected channel's fader levels, and the actual send levels are indicated by horizontal bars.
The information displayed here indicates whether the signal sent to the MIX channel is a pre- or post-fader signal. If
the indicator is green, it is a pre-fader signal; if gray, post-fader.
g
FX 1/2 box
Displays the FX 1/2 type.
When selected, you can use the [TOUCH AND TURN] knob to adjust the FX send level. Touch while selected to open
the FX screen.
Uses a white line to indicate the amount of signal from the selected channel that is sent to the FX BUS.
Send level, the selected channel's fader level, and the actual send level is displayed in the triangular bar.
The information displayed here indicates whether the signal sent to the FX BUS is a pre- or post-fader signal. If the
indicator is green, it is a pre-fader signal; if gray, post-fader.
h
Boxes
Touch while selected to open the configuration screen for the corresponding feature.
Touching the buttons of the EQ, DYN1, DYN2 or DELAY boxes turns the corresponding function ON/OFF.
(
HA box:
Displays the INPUT screen.
(
EQ box:
Displays the EQ screen.
(
DYN1 box:
Displays the DYN1 screen.
(
DYN2 box:
Displays the DYN2 screen.
(
DELAY box:
Displays the DELAY screen.
i
Channel output level meter
Displays the channel's output level.
j
Channel fader level slider
Adjusts the fader level for the selected channel.
k
ASSIGN box
Touch while selected to open the ASSIGN screen.
200
Channel-specific screens > CH VIEW screen