User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
MIX 1-6
Following is a description of the CH VIEW screen for MIX 1-6 channels.
d
g ih
fa cb
e
a
Channel name
Touch to display the CH NAME screen.
Touch the left/right buttons to display information for a different channel.
b
Recall Safe button
Touch to turn recall safe ON/OFF for that channel.
Touch the jump button on the right of the Recall Safe button to open the RECALL SAFE screen.
c
PAN/BAL slider
Adjusts the channel PAN/BAL.
d
Channel ON/OFF button
Turns the displayed channel ON/OFF.
e
SEND TO box
Touch while selected to open the SEND TO screen.
Uses a white line to indicate the amount of signal from the selected channel that is sent to the MATRIX channels.
Send levels, the selected channel's fader levels, and the actual send levels are indicated by horizontal bars.
The information displayed here indicates whether the signal sent to the MATRIX channel is a pre- or post-fader signal.
If the indicator is green, it is a pre-fader signal; if gray, post-fader.
201
Channel-specific screens > CH VIEW screen