User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
GEQ screen
The graphic EQ (hereafter GEQ) can be used on MIX 1-6 and STEREO channels.
The GEQ is a mono, 31-band EQ. Each band is 1/3 octave wide, with an adjustable gain range of ±15 dB.
The 31Band GEQ has 31 bands, of which you can adjust gain for up to 15 bands.
ba d e f
g ih
c
a
GEQ buttons
Turns the GEQ ON/OFF.
b
GEQ channel/LR Link selection buttons
Displayed when the signal type selected is MIX channel or STEREO channel.
They are not displayed when monorail or MIX channel are selected.
(
Chain icon:
Turns the LR Link ON/OFF.
(
L/R :
Switches the selected channel L or R.
c
Frequency characteristics, RTA display, gain controllable band selection
Displays the parameter characteristics/RTA.
Swipe left or right or touch an area to display the gain sliders for other bands.
When Fader Assign is turned ON, you can change which bands can be adjusted by the faders.
211
Channel-specific screens > GEQ screen