User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
Initialize Dante screen (DM3 only)
The Initialize Dante screen allows you to initialize the settings of the Dante module of the DM3 console.
a
a
INITIALIZE button
Initializes the settings of the Dante module of the DM3 console. After initializing, in order to reconfigure the
connected Dante device, we recommend first turning the DM3 console off and then on again.
NOTE
(
The module is initialized even if the Dante Device Lock is engaged. In such case the Dante Device Lock is unlocked after
initialization.
(
Domain registration of the Dante Domain Manager is released.
(
Labels corresponding to the DM3 IN/OUT channels are written to the Receive/Transmit Dante Channel Labels.
232
MAINTENANCE screen > Initialize Dante screen (DM3 only)