User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
Fader Calibration screen
In some usage environments, discrepancies may occur in the movement of motorized faders. The Fader
Calibration screen allows you to adjust this discrepancy.
cba
a
START button
Starts the calibration.
Touch to display the confirmation message. Touch the OK button to perform calibration.
b
Cancel button
Stops the calibration.
c
Apply button
Applies the calibration and exits.
Related links
(
“Calibrating faders”(p.294)
(
“If a fader must be calibrated again”(p.296)
235
MAINTENANCE screen > Fader Calibration screen