User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
Rear panel
Following is an explanation of the functions and names of parts of the rear panel of the DM3 Series.
d
c
e
a
b
gf
a
[OMNI OUT] jacks
XLR-3-32 type output jacks for outputting analog audio signals. These jacks are primarily for outputting MIX channels
and STEREO channels.
b
[INPUT] jacks
Connects to devices like mikes and musical instruments.
(
1 - 12:
XLR-3-31 input jacks
(
13 - 16:
Combo jacks compatible with both XLR and TRS phone plugs.
c
Power switch
When the switch is on (|), the power turns ON.
When the switch is on (z), the power goes to standby.
NOTICE
(
If 10 seconds elapse since the last operation, the power switch goes to standby. The state just before the power switch
went to standby is saved, and the system recovers to it when power comes back on.
(
To turn the power back on from standby, wait about 6 seconds or so. Turning the power ON and OFF repeatedly may
cause a malfunction.
26
Controls and functions > Rear panel