User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
d
[DC INPUT] connector
For connecting to the included power adapter. First connect this device to the power adapter and then plug it into
the electrical outlet.
WARNING
(
Only ever use the included power cord. Also, never use any other product with the included power cord. Damage,
overheating, and/or fire may result. The included power cord is designed specifically for Japan (up to 125 V).
CAUTION
(
Always put the console in standby prior to connecting or disconnecting the cord.
(
A small amount of electricity flows even when the power is OFF (on standby). When the product will not be used for a
long time, unplug the cord from the outlet.
e
Dante PRIMARY/SECONDARY connectors (DM3 only)
These connectors are for Dante audio network connections, such as I/O devices like the Tio1608-D. The connectors to
use are RJ-45 connectors that conform to etherCON CAT5e, made by Neutrik.
NOTICE
(
To prevent electromagnetic interference, use STP (Shielded Twisted Pair) cables. When using STP cables, make sure the
metal parts of connectors and shielded parts of cables are in contact with conductive tape or the like.
NOTE
Do not use the EEE function (*) of a network switch inside a Dante network. Power consumption settings are adjusted
automatically between switches that support the EEE function, but some switches do not correctly adjust these mutual
settings correctly. This means that in certain unfavorable cases with the Dante network, the EEE function of a switch might be
enabled, impairing the clock synchronization capability and causing audio to be interrupted. As such, please note the
following.
(
If using a managed switch, turn off the EEE function of all ports that use Dante. Do not use a switch that does not allow you
to turn off the EEE function.
(
If using an unmanaged switch, do not use a switch that supports the EEE function. Such switches cannot turn off the EEE
function.
*EEE (Energy Efficient Ethernet) function: A technology that reduces power consumption of an Ethernet device when network
traffic is sparse. It is also called “green Ethernet” or IEEE802.3az.
f
[USB TO HOST] connector
USB Type B Connector
The product functions as an up to 18 IN/18 OUT, 96 kHz/32-bit audio interface by connecting to a computer via USB
cables. It also allows control of DM3 series and remote control of DAW software by USB-MIDI.
It is necessary to install Yamaha Steinberg USB Driver in order to communicate with a computer.
NOTICE
(
Use USB cables under 3 m long.
(
Wait at least 6 seconds between unplugging and replugging USB cables.
27
Controls and functions > Rear panel