User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
Adjusting the compressor in 1-knob mode
This explains how to operate the compressor in the 1-knob mode.
1 Open the DYN2 screen.
2 Touch the DYN2 button to turn it ON.
3 Touch the 1-knob button to turn 1-knob COMP ON.
All DYN2 settings are overwritten.
4 Make adjustments with the [TOUCH AND TURN] knob.
Attack is fixed at 25 m, Release at 296 m and Knee Med; Threshold, Ratio and Out Gain are
linked to the operation of the [TOUCH AND TURN] knob.
Related links
“DYN2 (COMP) screen”(p.184)
278
Operating Screens > Channel-specific screens