User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
Adjusting the send to FX/MIX/MATRIX BUS level with faders
This explains how to configure send levels (SENDS ON FADER) to FX/MIX/MATRIX BUS with faders.
Using SENDS ON FADER allows you to manage each channel strip on the panel and adjust send levels and
turn sends to specific buses ON/OFF temporarily.
1 Touch the send to bus in the SENDS ON FADER area.
It displays channel names of the send to bus at the top of the channel name area.
The send levels of the send to bus are applied to the faders in the channel strip section on the
top panel.
2 Use the faders on the top panel to adjust the send level.
Press the [ON] key in the channel strip to turn send ON/OFF.
3 Touch Exit in the SENDS ON FADER area to exit the SENDS ON FADER mode.
You can also touch the [HOME] key /HOME button to exist the SENDS ON FADER mode.
Related links
“SEND TO Screen”(p.193)
285
Operating Screens > Channel-specific screens