User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
Using faders to adjust GEQ
This explains how to adjust GEQ with faders.
1 Open the GEQ screen.
2 Touch the Fader Assign button to turn it ON.
The current gain setting for each band is applied to the faders in the channel strip section on
the top panel. You can confirm the frequency and gain applied to each fader in the channel
name area of the display.
3 Swipe left or right on the gain sliders in the GEQ screen to select other bands.
You can swipe the EQ graph, RTA display, or band selection area left or right to select other
bands.
4 Use the faders on the top panel to adjust the gain.
If you press the [ON] key of a channel, you can reset the gain of frequencies assigned to that
channel to 0 dB.
5 After making adjustments, touch the Fader Assign button to turn it OFF.
It also turns OFF when you switch to another screen or enter the SENDS ON FADER mode.
Related links
“GEQ screen”(p.211)
287
Operating Screens > Channel-specific screens