User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
Calibrating faders
In some usage environments, discrepancies may occur in the movement of motorized faders. The Fader
Calibration screen allows you to adjust this discrepancy.
This feature automatically calibrates the specified fader (channel strip or main section fader).
1 Turn on the console while holding down the [HOME] key on the top panel.
The MAINTENANCE screen opens.
2 Touch the Fader Calibration button to open the Fader Calibration screen.
3 Press the [SEL] key on the top panel to select the fader you want to calibrate.
4 Touch the START button on the FADER CALIBRATION MODE screen.
294
Operating Screens > MAINTENANCE screen