User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
Analog output connections
Signals such as the output signals of output-related channels (MIX, MATRIX, STEREO (L/R), monitor signals
(MONITOR OUT L/R channel) and direct output signals of INPUT channels) can be patched to the OMNI OUT
connectors of the DM3 series and OUTPUT jacks of I/O devices.
The top panel of the DM3 series is equipped with a PHONES OUT jack for monitoring, so the signal selected
as the monitor source can always be monitored. In addition, that same signal can be monitored over an
external speaker by assigning the MONITOR OUT L/R channel to the desired output jack.
Tio1608-D
Monitor speaker
Main speaker
Switching of patches is configured on the SETUP screen → PATCH screen. Patch switching can also be made
from OUTPUT screen → OUTPUT CH PATCH screen.
Related links
(
“PATCH screen”(p.107)
(
“OUTPUT CH PATCH screen”(p.217)
(
“Default values of IN/OUT patches”(p.341)
31
Connections > Analog connections