User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
CONNECT area
The CONNECT area is for controlling the connection between DM3 Editor and the DM3 series console.
Status button
Click this button to switch between ONLINE/OFFLINE.
If DM3 Editor is connected properly with the DM3 series console, this button is displayed. When in this state,
the parameters of the DM3 Editor and the DM3 series console are linked.
If DM3 Editor is not connected to the DM3 series console, or if there is a problem with the connection, or if
offline editing is selected, this button is displayed.
When in this state, the parameters of the DM3 Editor and the DM3 series console are not linked.
NOTE
You can choose whether the channel selections are linked or not between DM3 Editor and the DM3 series console.
Configure it via Setup Menu → Channel Select Link.
312
DM3 Editor > Editor area