User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
CH STRIP area
The CH STRIP area displays a channel strip according to the selections of the FADER BANK of the DM3 Editor.
a
fd
b c
e
a
ON buttons
Turns the channel ON/OFF. This button lights when the channel is turned ON. In SENDS ON FADER mode, this button
controls whether the signal from the channel is sent to the currently selected MIX BUS, MATRIX BUS or FX BUS.
b
Fader value
Displays the current fader level value.
Click to select the fader (it turns pink) and then use the mouse wheel to adjust the level. Click again to specify a value
using your computer's keyboard. Press the [Enter] key on your keyboard to set the value. If you do not press the
[Enter] key, the fader reverts to its previous level when you click another part of the channel strip area or adjust a
DM3 series console fader.
c
Faders
Faders adjust the signal level of the channel. In SENDS ON FADER mode, faders control the send level from the
channel to the currently selected MIX BUS, MATRIX BUS or FX BUS.
Click to select the fader (it turns pink) and then use the mouse wheel to adjust the level.
In SENDS ON FADER, the fader knob changes color to match the channel color of the destination bus.
d
CH Display
Displays the channel's ID, color, and icon. Click to select the channel.
e
CUE buttons
This button selects the channel(s) for CUE monitoring. They light when ON.
f
CLEAR CUE buttons
Turns OFF the CUE for all channels.
318
DM3 Editor > Editor area