User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
MAIN/FX RTN/ST IN STRIP area
The MAIN/FX RTN/ST IN STRIP of DM3 Editor is the area where MAIN/FX RTN/ST IN channel strips are always
displayed.
a b
a
FX RTN/ST IN STRIP
Controls FX RTN and ST IN channels.
In SENDS ON FADER mode, the fader knob changes color to match the channel color of the destination bus.
b
MAIN STRIP
Controls the STEREO BUS.
In SENDS ON FADER mode, send destination channels are displayed as the MAIN strip. In addition, the fader knob
changes color to match the channel color of the corresponding bus.
319
DM3 Editor > Editor area