User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
Dante Network Connections
I/O device connections
A DM3 can be connected to a I/O device (such as Tio1608-D) in 2 ways--via a daisy chain or star connection.
In addition, devices with 2 ports, a main line (PRIMARY) and sub-line (SECONDARY) can be connected to each
other with a redundant connection, which is resistant to failures.
The DM3 can be easily configured with its Auto Setup function using a Dante patch to supported I/O devices.
Related links
(
“Dante”(p.342)
(
“Dante Auto Setup Function”(p.33)
(
“Daisy chain connections”(p.34)
(
“Star connections”(p.36)
(
“Redundant connections”(p.38)
32
Connections > Dante Network Connections