User Manual
Table Of Contents
- Table of contents
- Introduction
- Controls and functions
- Overview of screens
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Other fixed display areas
- MAINTENANCE screen
- Operating Screens
- SCENE screen
- RECORDER screen
- MONITOR screen
- SETUP screen
- LOGIN screen
- HOME screen
- DAW REMOTE screen
- Channel-specific screens
- Adjusting EQ in manual mode
- Adjusting EQ in 1-knob mode
- Configuring the HPF
- Configuring GATE/DUCKING
- Adjusting the compressor in manual mode
- Adjusting the compressor in 1-knob mode
- Setting effects
- Adjusting the send to MIX/MATRIX BUS level
- Setting the send to FX BUS level
- Adjusting the send to FX/MIX/MATRIX BUS level with faders
- Using GEQ
- Using faders to adjust GEQ
- Configuring mute safe
- Setting the send levels from output channels (MIX, STEREO) to MATRIX
- Recall presets
- Editing presets
- MAINTENANCE screen
- DM3 Editor
- Using the Editor
- Appendix
Daisy chain connections
A daisy chain is one way of connecting devices like a string of beads. It is a simple network structure with no
need for network switches. It is used for simple systems with only a few connected devices.
The more devices are connected, the more latency is required. In addition, if a system failure occurs, such as
a disconnected cable, it cuts off the network at that point, and communication with further devices in the
chain is lost.
n
Example of connection of AUTO SETUP DM3 and I/O device
Make connections as follows using the Dante connector of an I/O device with the DM3.
FX/MON OUTPUT
DM3
PRIMARY
1
2
1
PRIMARY
SECONDARY
Tio1608-D (UNIT ID:Y001)
DZR (UNIT ID:Y001)
DZR (UNIT ID:Y002)
MAIN
n
Configuration of I/O devices
Configure as follows when connecting to Tio1608-D or DZR-D/DXS-XLF-D using the DM3 AUTO SETUP
function.
34
Connections > Dante Network Connections